Graco SaniForce 24V311, Инструкция - Каталог запасных частей

Страница: 16 / 38

Operation
Start Start Start and and and Adjust Adjust Adjust the the the Pump Pump Pump
1. Set the pump air switch to ON. Slowly
increase pump air regulator pressure until
desired flow is achieved.
NOTE: NOTE:
NOTE: The pump regulator is set at the factory
to relieve pressure at 80 psi, the maximum inlet
pressure of the SaniForce 5:1 pump. SaniForce
2:1 and 6:1 pumps can use up to 100 psi. If more
supply pressure is needed for a 2:1 or 6:1 pump,
adjust the relief valve (209) on the back of the
pump regulator to relieve at higher pressures.
NOTICE NOTICE NOTICE
To avoid equipment damage, do not exceed
the maximum pressure rating of your pump.
2. Turn the pump air switch to OFF when
the drum is empty, or any time the pump begins
to run too fast.
NOTICE NOTICE
NOTICE
To avoid equipment damage, do not let the
pump runaway.
Change Change Change Drums Drums Drums
1. Set the pump air switch to OFF.
2. Open the fluid ball valve and/or dispensing valve
to relieve fluid pressure.
3. Mobile Mobile Mobile Models: Models: Models: Unlock the cart wheels.
4. Set the elevator director switch to UP to lift
the pump out of the drum.
5. Stationary Stationary Stationary Models: Models: Models: Remove the empty drum and
place the full drum against the elevator base.
Mobile Mobile
Mobile Models:
Models:
Models: With air connected and the
main air valve in the open position, the cart can
be moved short distances while the elevator is
raised. If you are going to turn off or disconnect
the air to move the cart, lower the elevator all the
way. Move the cart into position by a full drum.
6. With your hands away from the drum, set the
elevator director switch to DOWN.
Fully lower the pump into the drum. Mobile
Mobile Mobile
Models: Models: Models: Lock the cart wheels.
16 333406D