37
1.
For ease of installation, extend
LATCH
to its maximum length
and remove from storage bars.
2.
Position base in vehicle seat as
shown.
3.
Make sure
LATCH
is through
vehicle/LATCH belt path normally
used for vehicle seat belt.
.
Belt must lay flat and not be twisted.
4.
Hook
Connectors
to vehicle lower
anchors. Pull firmly on
Connectors
to
be sure they are attached
.
5.
Tighten
LATCH
by pushing down
hard on base and pulling the
adjustment belt
.
6.
NEVER
put two
LATCH
connectors
on one vehicle
LATCH
anchor unless
specifically allowed by the vehicle
manufacturer
.
7.
Test infant restraint for secure
installation as described in infant
restraint
„ Final Safety Check‰ page.40.
8.
Check that the
LATCH
stays tight
and does not slip from the tightened
position. If it does not stay tight, try another
seating position or contact Graco at 1-800-345-4109.
7.3 Using LATCH to install Base
Содержание Quattro Tour 1749531
Страница 85: ... 2008 Graco PD100628A 7 08 US ...