Graco Magnum Pro Compact A15 258861, Руководство по эксплуатации

Страница: 20 / 28

Troubleshooting
20 3A0885E
Spray Pattern Diagnostics
Sprays with poor results Tip is partially clogged See Unclogging Tip/Guard Assembly,
page 14.
Tip is not in correct position Rotate tip to SPRAY position.
Incorrect tip for application of
material. See Reversible Tip Selection Chart,
page 12.
Tip filter is partially clogged Clean or replace filter. See page 14.
Suction Tube screen is partially clogged. Clean or replace Suction Tube. See page
15.
Fine Finish Optimizer is partially clogged. Clean or replace Fine Finish Optimizer.
See page 9.
Fine Finish Optimizer is installed while
using an incompatible material. Make sure compatible material is being
used. See Reversible Tip Selection
Chart, page 12.
Tip is worn or damaged Replace tip. See Install Tip/Guard
Assembly, page 12.
Inlet or Outlet Valves are worn. Replace sprayer.
Paint leaks from sprayer trigger area. Sprayer has reached its maximum life. Replace sprayer.
Battery is discharged but charger still dis-
plays green light when battery is inserted. Damaged battery. Replace battery.
Problem Cause Solution
Problem Cause Solution
Spray pattern is pulsating: Fine Finish Optimizer is installed while using
an incompatible material.
Operator is moving too fast while spraying.
Make sure material is compatible. See Revers-
ible Tip Selection Chart, page 12.
Slow speed of movement.
Spray pattern has tails: Fine Finish Optimizer is installed while using
an incompatible material.
Fine Finish Optimizer is partially clogged.
Material not compatible with sprayer.
Inlet or Outlet Valves are worn.
Make sure compatible material is being used.
See Reversible Tip Selection Chart, page 12.
Clean or replace Fine Finish Optimizer.
See page 9.
Switch material.
Replace Sprayer.
Spray pattern has dripping: Sprayer is moving too slow for material.
Sprayer is too close to target surface.
Holding trigger while changing spray
direction.
Incorrect tip for application of
material.
Tip is worn or damaged.
Move sprayer faster while spraying.
Move sprayer away from surface (10 in).
Release trigger when changing directions.
See Reversible Tip Selection Chart, page 12.
Replace tip. See Install Tip/Guard Assembly,
page 12.
Spray pattern is too narrow: Sprayer is too close to target surface.
Incorrect tip for application of material.
Tip is worn or damaged.
Move sprayer away from surface (10 in).
See Reversible Tip Selection Chart, page 12.
Replace tip. See Install Tip/Guard Assembly,
page 12.
ti15524
ti15526
ti15522
ti15523