Connect
Connect
Connect the
the
the Fluid
Fluid
Fluid Hose
Hose
Hose from
from
from the
the
the Gun
Gun
Gun to
to
to the
the
the
Cabinet
Cabinet
Cabinet
1.
Blow the waterborne fluid hose out with air and
flush with flushing fluid to remove contaminants.
2.
Connect the Graco waterborne fluid hose to the
gun as described in the spray gun manual. See
the spray gun manual for hose information and
dimensions.
3.
Connect the fluid hose to the fluid pressure
regulator inside the isolation cabinet. Before
entering the cabinet:
a.
Follow the
.
b.
Follow the
Pressure Relief Procedure, page 30
.
c.
Open the cabinet and slide the electrostatic
shield (12) up to remove.
4.
Remove the fluid outlet strain relief ferrule (38)
from the strain relief housing.
Figure 8 Shielded Hose Connection with Fluid
Regulator
Figure 9 Shielded Hose Connection without
Fluid Regulator
5.
Slide the strain relief ferrule (38) over the
conductive hose layer (FC) until it reaches the
abrasion layer (FJ)
Figure 10 Fitting to Abrasion Layer on
Waterborne Fluid Hose
6.
In this position, the fitting clamps onto the
conductive segment (FC) of the hose when
tightened.
Conductive hose layer (FC) must be grounded
through its connection to the isolation system’s
grounded cabinet (CA). To maintain grounding
continuity, the conductive hose layer (FC) must
be engaged in the ferrule when the strain relief
nut is tightened. Failure to properly install the
hose in the strain relief could result in an electric
shock.
7.
Feed the hose tube (FT) through the strain relief
housing into the cabinet until it reaches the tube
compression fitting (82) on the fluid regulator or
pump outlet fittings. Unscrew the nut portion
of the fitting. The nut portion is comprised of 3
pieces (82a, 82b, 82c).
18
3A8493A
Содержание HydroShield WABL00
Страница 118: ...Parts Notes Notes Notes 118 3A8493A...
