Graco Hydra-Spray EH 433 GT 226-432 L Series, Инструкция-перечень запасных частей

Страница: 8 / 28

SETUP
PACKING NUT/
WET–CUP
FILL 1/3 FULL
WITH TSL
Fig 1
ON/OFF SWITCH
Pull on/Push off
1/4 npsm(m) FLUID
OUTLET NIPPLE
DO NOT INSTALL ANY
SHUTOFF DEVICE HERE
PRESSURE ADJUSTING
KNOB
PRESSURE DRAIN VALVE
DO NOT INSTALL A SPRAY HOSE HERE
FULL
ADD
STRAINER
DIPSTICK
PUSH CLIPS TO
RELEASE SHIELD
1
Check the Hydraulic Fluid (See Fig 1.) Push in on
the two spring clips and lift the shield off the sprayer.
Remove the expander plug from the sump fill hole
and lift the strainer/dipstick out of the hole. Using a
clean, lint–free cloth, wipe the dipstick clean, replace
it in the sump hole, and then remove it and check the
fluid level. The fluid level should be between the ADD
and FULL marks on the dipstick.
If the fluid level is at or below the ADD mark, replace
the strainer/dipstick in the sump hole. Add approved
hydraulic fluid (see ACCESSORIES) through the
hole to bring the level to the FULL mark. One and
three–fourths pints will raise the level from ADD to
FULL.
If you are supplying your own hoses and spray gun,
be sure the hoses are electrically conductive, that
the gun has a tip guard, and that each part is rated
for at least
3000 psi (210 bar) Working Pressure .
This is to reduce the risk of serious bodily injury
caused by static sparking, fluid injection or over–
pressurization and rupture of the hose or gun.
WARNING
2
Connect the gun, 3 ft. hose and 50 ft. hose. Don’t
use thread sealant, and don’t install the spray tip yet.
3 Fill the packing nut/wet–cup 1/3 full with Graco
Throat Seal Liquid (TSL), supplied. T o access the
cup, push in on the two spring clips and remove the
sprayer shield. See Fig 1.