Graco Husky 2200F, Инструкции по эксплуатации

Страница: 10 / 24

Installation
Ground The System
The equipment must be grounded to reduce the
risk of static sparking. Static sparking can cause
fumes to ignite or explode. Grounding provides an
escape wire for the electrical current.
• Always ground the entire fluid system as
described below.
• Polypropylene and PVDF pumps are not
conductive and are not for use with flammable
fluids.
• Follow your local fire codes.
Before operating the pump, ground the system as
explained below.
• Pump: Always ground the entire fluid system by
making sure the fluid has an electrical path to a
true earth ground.
• Air and fluid hoses: Use only grounded hoses
with a maximum of 500 ft (150 m) combined hose
length to ensure grounding continuity.
• Air compressor: Follow manufacturer’s
recommendations.
• Fluid supply container: Follow local code.
• Solvent pails used when flushing: Follow local
code. Use only conductive metal pails, placed
on a grounded surface. Do not place the pail
on a nonconductive surface, such as paper or
cardboard, which interrupts grounding continuity.
Check your system electrical continuity after the
initial installation, and then set up a regular schedule
for checking continuity to be sure proper grounding
is maintained.
Air Lines
1. Install an air filter/regulator assembly (C). The
regulator controls the fluid pressure. The fluid
stall pressure will be the same as the setting of
the air regulator. The filter removes harmful dirt
and moisture from the compressed air supply.
2. Locate a bleed-type master air valve (B) close to
the pump and use it to relieve trapped air. Be
sure the valve is easily accessible from the pump
and located downstream from the regulator.
Trapped air can cause the pump to cycle
unexpectedly, which could result in serious
injury from splashing.
3. Locate another master air valve (D) upstream
from all air line accessories and use it to isolate
them during cleaning and repair.
4. Install a grounded, flexible air hose (A) between
the accessories and the 3/4 npt(f) pump air inlet.
10 3A2578C