Graco 259079, Инструкции по эксплуатации

Страница: 60 / 102

Jog Mode
Circulation Through Gun Manifold
NOTICE
Do not circulate fluid containing a blowing agent
without consulting with your material supplier
regarding fluid temperature limits.
Circulating fluid through the gun manifold allows
rapid preheating of the hose.
1.
Install gun fluid manifold (P) on accessory
circulation kit (CK). Connect high pressure
circulation lines (R) to circulation manifold.
P
CK
R
The Fusion AP gun manifold is shown.
CK Gun Manual
246362 Fusion AP 309818
256566
Fusion CS
313058
GC1703 Probler P2 313213
2.
Route circulation lines back to respective
component A or B supply drum. Use
hoses rated at the maximum working
pressure of this equipment. See
Technical Specifications, page 98.
3.
Follow procedures from Startup, page 55.
4.
Turn main power switch on .
5.
Set temperature targets. See Targets, page 50.
6.
Press to circulate fluid in jog mode until
A and B temperatures reach targets. See
Jog Mode, page 60 for more information about
jog mode.
Jog Mode
Jog mode has two purposes:
• It can speed fluid heating during circulation.
• It can ease system flushing and priming.
1. Turn main power switch on .
2. Press circulate to enter jog mode.
3. Press up or down to change jog speed
(J1 through J20).
Note
Jog speeds correlate to 3-30% of motor
power, but will not operate over 700 psi
(4.9 MPa, 49 bar) for either A or B.
4. Press to start motor.
5. To stop the motor and exit jog mode press
or .
60 3A1705E