Graco 24F883, Инструкция по эксплуатации

Страница: 6 / 30

Typical Installation
6 312668ZAC
Typical Installation
The installation shown in F
IG
. 1 is only a guide for
selecting and installing system components. Contact
your Graco distributor for assistance in planning a
system.
Dispense valves can also be installed on a console as
shown in F
IG
. 2.
Key:
A Metered dispense valve
B Fluid shut-off valve
C Hose
D Hose reel fluid inlet hose
E Hose reel
A Thermal Relief Kit (not shown) is required. The kit will
vary depending upon the pump. See Kits and
Accessories , page 27 for available kits.
Mounting Bracket
Mounting bracket (P/N 196471) is available for resting
dispense valve on the counsel (F
IG
. 2).
F
IG
. 1
B
D
E
C
A
NOTICE
• Do not use this dispense valve on non-Graco
consoles.The trigger could be inadvertently
pressed while the dispense valve is stowed.
• This dispense valve is not designed for in-line
installation. Do not install with a shut off valve on
the outlet side of the meter to avoid damaging the
meter housing cover.
NOTICE
Do not obstruct the dispense valve trigger or and do
not set the unit down resting on the trigger, or the
dispense valve may not stop dispensing.
F
IG
. 2
Mounting Bracket
196471