4
308544
Installation
WARNING
Pressure Relief Procedure
To reduce the risk of serious bodily injury, including
fluid injection and splashing in the eyes or on the skin,
always follow this procedure whenever you stop
spraying for more than 10 minutes, when shutting
down, and before checking or repairing any part of
the system.
1. Engage the trigger safety latch.
2. Turn the sprayer off.
3. Remove the ignition cable from the spark plug,
disconnect the air or disconnect the electricity.
4. Shut off the water supply.
5. Disengage the trigger safety latch and trigger the
gun to relieve pressure, and then engage the
trigger safety latch again.
NOTE:
Check the spray tip application chart (308514)
to order the proper spray tip for your model of
pressure washer.
Refer to the Parts Drawing on page 7 for the
numbers in parentheses in the text.
1. Remove the tip and male quick coupler from the gun
assembly.
Keep these parts for reinstallation on the
gun after sandblasting.
2. Assemble the spray tip (not supplied with kit), to the
tip adapter (4) and male quick coupler (5). Use pipe
sealant on all threads. Connect the assembly to the
female quick coupler on the gun.
3. Assemble the mixer housing (2) to the adapter (4).
Be sure that the sand inlet is located at the top of the
mixing head. See the Parts Drawing.
4. Attach the sand hose (10) to the mixing head.
5. Attach the other end of the sand hose to the sand
probe (1).
to order the proper spray tip for your model of
Refer to the Parts Drawing on page 7 for the
numbers in parentheses in the text.
5. Disengage the trigger safety latch and trigger the
gun to relieve pressure, and then engage the
Check the spray tip application chart (308514)
to order the proper spray tip for your model of
Refer to the Parts Drawing on page 7 for the
numbers in parentheses in the text.
to order the proper spray tip for your model of
Refer to the Parts Drawing on page 7 for the
numbers in parentheses in the text.
Содержание 244766
Страница 9: ...9 308544 Notes ...