Graco 224-605, Руководство пользователя

Страница: 10 / 32

10
STARTUP
PUMP
STRAINER
ON/OFF SWITCH
PRESSURE ADJUSTING KNOB
PRESSURE DRAIN VALVE
Fig 2
CCW TO
LOWER PRESSURE
HOSE RACK
SUCTION TUBE
TRIGGER SAFETY LATCH
SHOWN ENGAGED (ON SAFE)
SPRAY TIP
TIP GUARD
DETAIL
1. Prime the sprayer with paint.
a. Close the pressure drain valve.
b. Don’t install the spray tip yet!
c. Put the suction tube into the paint.
d. Turn the pressure adjusting knob counter-
clockwise to lower the pressure.
e. Disengage the gun safety latch.
f. Hold a metal part of the gun firmly against
a grounded metal pail. See Fig 3.
Squeeze the trigger, turn the ON/OFF
switch to ON, and slowly increase the
pressure until the sprayer starts. Keep the
gun triggered until all air is forced out of
the system and the paint flows freely from
the gun. Release the trigger and engage
the safety latch.
NOTE: If the pump is hard to prime, open the
valve. When fluid comes from the valve,
close it. Disengage the gun safety latch
repeat Step 1f.
g. Check all fluid connections for leaks.
Follow the Pressure Relief Procedure
Warning on page 9 before tightening any
loose connections.
2. Install the spray tip and tip guard. Be sure
the gun safety latch is engaged. Follow the
instructions supplied with the tip guard.
Fig 3
MAINTAIN FIRM
METAL-TO-METAL
CONTACT BETWEEN
GUN AND GROUNDED
METAL CONTAINER
GROUND
WIRE
0664