Graco 205394, Инструкция-перечень запасных частей

Страница: 4 / 18

Installation
4 306674W
Installation
Grounding
Pump: Use a ground wire and clamp as shown in F
IG
. 1.
Air and fluid hoses: Use only electrically conductive
hoses.
Air compressor: Follow manufacturer’s recommenda-
tions.
Dispense valve: Ground through connection to a prop-
erly grounded fluid hose and pump.
Object being dispensed: follow local code.
Solvent pails used when flushing: Follow local code.
Use only conductive metal pails, placed on a grounded
surface. Do not place the pail on a nonconductive sur-
face, such as paper or cardboard, which interrupts
grounding continuity.
To maintain grounding continuity when flushing or
relieving pressure:
hold metal part of the spray
gun/dispense valve firmly to the side of a grounded
metal pail, then trigger the gun/valve.
To ground the pump: Remove the ground screw (Z)
and insert through the eye of the ring terminal at end of
ground wire (Y). Fasten the ground screw back onto the
pump and tighten securely. Connect the other end of the
ground wire to a true earth ground. See F
IG
. 1. To order
a ground and wire clamp, order Part No. 222011.
Mounting the Pump
• Select a convenient location for the equipment to
ensure easy operator access to the pump air con-
trols, sufficient room to change supply containers,
and a secure mounting platform.
• If you are mounting the pump directly on the supply
tank, position the pump so its intake valve is no
more than 1 inch (25 mm) from the bottom of the
container. Mount the pump to the cover or other suit-
able mounting device.
Typical Installation
Mount the pump to suit the type of installation planned.
Very heavy lubricant may require an inductor plate. See
page 17 for the mounting hole layout and dimensions.
Install the airline accessories in the approximate order
shown in F
IG
. 2. Install a bleed-type master air valve (B)
within easy reach of the pump, upstream from the air
regulator. Install an air filter (C) to remove harmful dirt
and moisture from your compressed air supply. For
automatic air motor lubrication, install an air line oiler (D)
close to the pump air inlet. Install an air regulator (E) to
control pump speed.
The equipment must be grounded to reduce the risk
of static sparking and electric shock. Electric or static
sparking can cause fumes to ignite or explode.
Improper grounding can cause electric shock.
Grounding provides an escape wire for the electric
current.
F
IG
. 1
Y
Z
Mount the pump securely so that it cannot move
around during operation. Failure to do so could result
in personal injury or equipment damage.