The vertical angle of the microphones can be adjusted by loosening the stand clamp locking handle
and then rotating the horizontal bar to the desired angle. For reference there is a +/-90° scale on the
side of the stand clamp. The stand clamp locking handle is adjustable and is set from the factory to
provide a good clamping force with the handle pointing downward. To adjust the angle of the handle
pull the handle back from the stand clamp while rotating. When released, the handle will snap back
and engage in the new position.
fig.3 Spacebar vertical angle adjustment
Setup Procedure
1. On the mic holder assemblies, loosen the position locking nut and the angle locking screw and
set the angle to 0°. Tighten both again.
2. Thread on the microphone clips for your desired microphones but do not tighten all the way.
Put the microphones in the clips and while looking down on the Spacebar from above, point
the mics so that they are pointing straight forward and are perpendicular to the horizontal bar.
While holding the microphone in this position, turn the jam nut counter clockwise until the clip is
securely locked.
Stereo Spacebar User Manual Revision C
Page 5 of 13
