6
Step 3: Hardware to Pole Mounting Ends
Parts Needed:
Right and Left Mounting Ends
4 - 5/16" x 2" Carriage Bolts
4 - 1/4" Smaller Flat Washers
4 - Jamb Nuts
<
Note direction carriage bolt goes through the part.
<
Tighten nuts on carriage bolt to pull the square part of the
bolt into the wood until the bolt is seated into the wood
part.
Step 4: Base Feet to Diagonal Stands
Parts Needed: Right and Left Base Feet
2 - Diagonal Stands (w/ Hardware Installed)
2 - Wing Nuts
2 - Nylon Lock Nuts
4 - 5/16"Large Flat Washers
<
As shown in drawing (right), position carriage bolt ends through
holes in base legs.
<
For ease of tightening, thread flat washers and lock nuts onto the
bottom carriage bolts first.
<
**Nylon side of nylon lock nuts faces out when threading
onto the Bolt end.**
<
**Leave all nylon lock nuts loose enough to slide the joint.**
<
Next, thread the washers and wing nuts on the top carriage bolts.
Step 5: Pivot Sections to Diagonal Stands
Parts Needed:
Right and Left Pivot Sections (w/ Hardware Installed)
2 - Wing Nuts
2 - Nylon Lock Nuts
4 - 5/16" Large Flat Washers
<
Align the carriage bolts that are already installed on
the pivot sections and the diagonal stands through the
holes as shown on the pictures (right).
<
Notice that the flat washer and wing nut are threaded
onto the end of the lower carriage bolt toward the
outside of the frame. The washer and nylon lock nut
are loosely threaded onto the upper carriage bolt
toward the inside of the frame.
Step 6: Ratchet Wheels to Poles
