Device Description HG G-71450/1/3/5-A | English, Revision 02 | Date: 06.06.2019
26
Chapter 4 – Installation and Commissioning
4.4 Interface HG 06150Y (optional for HG G-71450)
The optional serial/parallel interface must be installed on a mounting bar. The func
-
tion is described in section 5.6 on page 31. The interface has the following pin as
-
signment:
Figure 13
Structure of the interface mounting bar housing
NOTICE
Risk of damage to the device or to other devices on the CAN Bus
The connectors ST1 (Power) and ST3 (CAN) of the antenna HG G-71453 with
CAN Bus connection are mechanically identical. Thus there is the danger of
mixing up the corresponding connectors.
Pay particular attention to the correct placement of the ST1 and ST3
connectors on this antenna.
Table 17
Pin assignment of the interface mounting bar housing
Assignments of the mounting bar housing
1
Code Bit 1 (low-order bit)
15 Code Bit 15
2
Code Bit 2
16 Code Bit 16 (highest-order bit)
3
Code Bit 3
17 Data Ready
4
Code Bit 4
18 Data Valid
5
Code Bit 5
19 n. c.
6
Code Bit 6
7
Code Bit 7
8
Code Bit 8
9
Code Bit 9
10 Code Bit 10
11 Code Bit 11
20 Rx+ (RS 232 input)
12 Code Bit 12
21 n. c.
13 Code Bit 13
37 +24 V supply voltage
14 Code Bit 14
38 GND mass