OPERATION OF THE DEVICE
The device is protected from incorrect assembly. The function assures that the device may be turned on if
properly assembled. After proper assembly the built-in micro-switch found in the device is unlocked.
- assembled device has to be placed on the stable and flat surface
- connect the device to the network, the display shall switch on
- vegetables and fruit shall be washed and divided into pieces which match the size to the dosing tunnel found
in the cover (1)
- make sure that the container for juice was placed under the outlet (7)
- make sure that the container for pulp was placed under the outlet (6)
- select one of the device operation modes by means of turning the switch knob to the right or to the left. The
selection of the function is confirmed by a short sound signal and the selected function appears on the display.
(3) hard vegetables or fruit such as carrots, beetroot, celery, etc. - worm rotations of 40RPM
(4) apples, peaches, plums, etc. - worm rotations of 30RPM
(5) soft fruit or vegetables such as strawberries, tomatoes, etc. - worm rotations of 20RPM.
Soft products may be squeezed out at higher worm rotational speeds.
Do not squeeze out hard products on
lower than recommended worm rotational speeds!
- the engine starts by means of pushing the switch knob and after a few seconds reaches the optimum working
speed
- products prepared shall be placed individually into the dosing tunnel found in the cover (1) and using a
pusher gently push it towards the worm
- do not exercise too much pressure on the pusher as it may worsen the juice quality or damage the device
Never put your fingers or any other objects into the dosing tunnel!
- juice will flow down directly into the container and wastes shall be collected in a separate container
- in order to stop the engine operation it is necessary to push the switch knob
- if the worm is blocked, it is necessary to stop the device by means of pushing the knob, turning it in order to
select the cleaning function (2) and push the knob and then wait until the device automatically runs the
cleaning cycle
After processing the whole product, it is necessary to close the cap of the juice outlet, turn off the device and
wait until it stops and then disconnect it from the power socket.
The device is equipped in the cap which prevents from juice dripping from the device when under the juice
outlet no container is located. While squeezing out juice the cap shall be open.
It is necessary to observe the device continuous operation time (10 minutes). Exceeding of the
operation time and lack of sufficient breaks in the operation may lead to irreversible damage of the
engine or other device elements.
The engine is equipped in thermal protection system. If the engine is overheated, the device automatically
stops. It is necessary to turn off the device and wait around 20 minutes until the engine cools down.
INDICATIONS CONCERNING JUICE SQUEEZING OUT
Use fresh fruit and vegetables as they contain the greatest amount of juice. The efficiency of the device
depends mostly on the quality of fruit and vegetables.
- thoroughly clean fruit and vegetables from which juice will be squeezed out
- it is recommended to blanch the products the origin of which may raise doubts regarding the way of their
cultivation especially fertilization
– remove hard, inedible peels from the processed products (e.g. melon, orange, pineapple, mango, etc. peels)
and kernels, hard seeds and skins
- processed products shall be divided into pieces which match the dosing tunnel with their size
- it is not allowed to process ice or frozen fruit or vegetables
– some juice get dark quickly and it is a natural process which can be slowed down by means of adding a few
drops of lemon juice
- the device is not suitable for squeezing out juice from very hard and rich in starch fruit or vegetables, e.g.
sugar cane
- dry fruit or vegetables such as bananas are not suitable for squeezing out
- in order to achieve the best efficiency while squeezing out fruit and vegetables of various consistency it is
necessary to process soft products first and then hard ones
