Gorenje VCK 1800 WF, Инструкция по эксплуатации

Страница: 25 / 58

24
3. Fill the water container with ordinary tap
water up to the MAX H2O indicator as
shown in figure 3.
The required quantity is 600cc of water. Replace
the filter assembly in the water container, being
careful to align them perfectly. Put the water
container back inside the appliance.
ASSEMBLY OF THE SUCTION HOSE
•
Insert the flexible suction hose into the
connection opening at the top of the
housing until you can feel it lock.
HOSE REMOVING
•
To remove flexible hose from the vacuum
cleaner, press the buttons situated on the
flexible hose base, then pull to remove it
from the attachment point.
ROLLING THE CABLE OUT AND UP
•
Pull out the cable to such a length that easy
working is ensured. Now connect the
appliance to the main supply. Press the
switch to activate the automatic rewinder
and hold on the mains plug for safety
reason.
FITTING TELESCOPIC TUBE AND
ACCESSORIES
•
Extend the telescopic tube to the desired
length by pressing on button.
•
Insert a flexible hose into a telescopic tube.
•
Fit a nozzle to telescopic tube:
-
Floor brush is intended for cleaning
bare floor and floor coverings.
- Crevice/furniture nozzle is for cleaning
corners and between cushions.
According to the mark rotate the nozzle
to brush position to clean curtain or
dust on the decorating surfaces.
Instruction for use
•
Before using the appliance, unwind a
sufficient length of cord and insert the plug
into the power supply.
•
Press the On/Off button to switch the unit
on. To stop it press the On/Off button again.
•
You can adjust the air flow using the air flow
regulator on the flexible hose:
-
decrease power for cleaning curtains,
books, furniture, etc.
- increase power for cleaning bare floor.
To rewind the cord, press the rewind button and
guide the cord with hand to ensure that it does
not whip causing damage.
DRY SUCTION
The appliance is used in the same way to vacuum
up dust. If the water is very dirty, replace it as
described in the section on “Emptying and
cleaning the water container”. When the dirt
collected in the water container is enough, the
suction will be powerless. The motor also will
turn over audibly faster. It reminds the
operators turn off the power . To resume
cleaning, perform the operations described in the
section on emptying and cleaning the container,
then top up the water level in the container.
Floor Brush
Extension Tube