Gorenje Ora-Ito GV60ORAB, Руководство по эксплуатации

Страница: 26 / 32

Placing the dishwasher
The dishwasher is intended to be built-in
under a worktop. The built-in
measurements are shown in the
illustration. Make sure that the cable and
hose hole’s edges are even and will not
damage the drainage and inlet hoses or
the power cable.
570
55
125
820-870
[mm]
Affix the protective film
Attach the protective film (packed in the
document bag) to the underside of the
worktop. The protective film is to protect
the worktop from moisture.
NOTE!
The surface to which the protective film
is affixed must be clean and dry.
Adjust the height and slide the
dishwasher into place
1 Start by measuring the height from the
floor to the bottom edge of the worktop.
2 Measure the height from the floor to the
top edge of the dishwasher.
3 Adjust the dishwasher's feet by turning
them clockwise to raise or anticlockwise
to lower the machine.
2x
4 Check that there is an air gap of at least
3 mm between the underside of the
worktop and the top edge of the
dishwasher.
5 Slide the dishwasher into place.
• Pull through the drainage and supply
hoses when the machine is slid into
place.
• Check that the hoses have no kinks
or sharp bends, and check that there
is nothing that can damage the
hoses.
• Check that the machine is installed
such that the door opens freely,
otherwise door lock functionality may
be disrupted.
6 Make any final adjustments to the front
feet (the dishwasher may lean no more
than 5 mm).
Drainage connection
This dishwasher is suitable for installing
in a raised recess (to attain an ergonomic
26