Gorenje IDT 9640 X, Инструкция по эксплуатации

Страница: 11 / 15

11
4.3 Fan speeds
The lowest and medium speeds should be used under normal conditions and with low concentration of
fumes. The top speed should be used in case of high concentration of kitchen fumes, e.g. during frying or
grilling.
1. Operational safety
All safety instructions included in this manual shall be observed without exception!
Grease filters and active carbon filters should be cleaned and replaced according to manufacturer’s
instructions, or more frequently in periods of intensive use (more than 4 hours a day).
If a gas cooker is used it is forbidden to leave uncovered flame. When removing pots from gas burners set the
flame to its minimum level.
Always make sure that flame does not extend outside the pot. Such a situation causes undesired energy losses
and dangerous heat build-ups.
The hood should not be used for other purposes than those for which it was designed.
2. Operation
2.1 Control panel
Operation of the hood can be controlled by means of a combined switch.
Sensor ''Slider''- adjust the fan speed level, ranging from 1 to 9,
Sensor ''On / Off''(I / 0)
- turns on and off the fan
-
turns on the fan, on last memorized fan speed,
-
longer touch “on / off” sensor, when the fan is turned on, 5 min. timer is on (informing - a dot on
the display).
Sensor ''Light''(L)
-
turns on / off lighting
-
longer touch causes a gradual brightening / dimming of lighting, on 3 levels of 100, 75 and 50%
2.2. Program function
Timer function: IDT 9640 X kitchen extractor hood is equipped with the option of programming automatic
switch-off of the hood fan after 5-minute. “Timer” is actuated by pressing „I/0” indicator during operation of
the hood with the required fan speed. The display will flash and a dot will appear indicating that the device is
in the switch-off time programming mode. After setting the delay pulsating dot will indicate that the time to
switching off of the hood motor is being counted.
TIMER function can be cancelled by pressing “I/0” indicator again during counting of the time.
NOTE: The program always memorizes the last delay setting.
The microprocessor system may get deleted or crash during momentary voltage drops in the network,
and stop responding to commands from the keyboard. In such case the hood has to be disconnected
from and then connected again to the power network in order to reset the system.
VI Operation and maintenance