Gorenje GV63315UK, Инструкция по эксплуатации

Страница: 24 / 30

Positioning the Appliance
How to Drain Excess Water From Hoses
If the sink is 1000 higher from the floor, the exces s water in hoses cannot be drained di rectly
into the sink. It will b e necessary to d rain excess water from hoses into a bowl or suitable
container that is held outside and lower than the sink.
Water Outlet
Connect the water d rain hose. The d rain hose must b e co rrec tly fi tted to av oid wate r leaks.
En sure that the wat er inlet hose is not kinked or s quashed.
The following things should be checked before starting the dishwasher.
Syphon Connection
Insert the drain hose into a d rain pipe with a minimum diameter of 40mm, or let it run into th e sink, making sure to
avo id bending o r crimping it . The top of the ho se mus t be less than 100 0mm.
The content of this manual is very helpful to the users.
After installation, please make sure to keep this manual.
Extension Hose
If you n eed a drain hose extensi on, make sure to use a similar dra in ho se.
It must be no longer than 4 metres; o therwise the cleanin g effect o f the dishwasher could b e re duced.
1 The dishwasher is level and fixed properly
2 The inlet valve is open
4 The wires are tightly connected
5 The power is switched on
6 The inlet and drain hoses are knotted
7 All packing materials and printings should be taken out from the dishwasher
Position the appliance in the desired location. The back should rest against the wall behind it, and the sides,
along the adjacent cabinets or walls. The dishwasher is equipped with water supply and drain hoses that can
be positioned either to the right or the left sides to facilitate pro per installation.
3
Fill hose connections are fully tightened and not leaking
A hose that attaches to a sink spray can burst if it is in stalled on th e sa me wate r line as the dish washer. If your si nk
has on e, it is re commended thet the hose be disconnected an d the hole plugged.
The safety supply hose consists of the double wa lls. The hose's system guarantees its intervention by b lock ing the
flow of water in case of the supply ho se b reaking and whe n the air space between the supply hose itself and the oute r
corrugated hose is full of water.
5VSO PGG UIF XBUFS
3FMFBTF UIF XBUFS QSFTTVSF CZ EFQSFTTJOH UIF QSFTTVSF SFMFBTF CVUUPO 5IJT SFMJFWFT XBUFS QSFTTVSF BOE QSPUFDUT ZPV BOE UIF SPPN GSPN TFWFSF
TQMBTIJOH
6OTDSFX 5IF TBGFUZ TVQQMZ IPTF GSPN UIF GBVDFU
Connect the cold water supply hose to a threaded 3/4(inch) conn ector and make su re t hat i t is fastened tight ly in place.
If th e water p ipes are new or have not been use d for an e xtended period of time, let the water ru n to make sure that th e
wate r is clear and free of impurities. If this preca ution is not taken, there is a ri sk th at the water inlet can get blocked
and damage the appl iance.