Gorenje GDV641XL, Руководство пользователя

Страница: 11 / 132

11
Rinse aid / Salt
Pour in rinse aid
Rinse aid, helps quicken the drying process.
Machines with indicator on the panel
When the rinse aid has run out and more is needed, the
rinse aid symbol on the panel lights up*.
To fill with rinse aid:
Turn and lift up the cover of the rinse aid compartment
to the right of the dispenser. This is where you top up
and set the amount of rinse aid to be dispensed in each
wash.
Carefully pour in rinse aid up to the knob for dosage
setting.
Alter dosage if required. Do not forget to close the cover.
*NOTE!
After filling there may be a short delay before the signal
light goes out.
Machines with refill indicator
There is a refill indicator in the middle of the dispenser
(see picture). If the refill indicator is totally black, there is
sufficient rinse aid. However, if the indicator has a more
transparent appearance, you need to top up with rinse
aid (see above).
Select dosage
The dispenser is usually set at 1= soft water. However,
depending on the water hardness, it may be necessary
to change the dosage.
Open the rinse aid cover. Here you will find the
dispenser’s adjustment dial. Settings 1-6: the harder the
water, the higher the dosage.
When the water hardness exceeds 10-12 °dH you
should use rinse aid with citric acid (acid rinse aid) if
the machine does not have a water softening filter. If the
machine has a water softening filter, dispense as for soft
water.
Too much rinse aid can lead to the build-up of foam. If
your water is particularly soft, you can dilute the rinse aid
(1 part rinse aid, 1 part water).
Too much rinse aid can cause streaks on the dishes,
while too little can result in water stains.
Add salt
Before using a dishwasher with a water softening filter,
you must fill the salt compartment with salt. Use coarse
salt or special salt for dishwashers.
It is best to fill with salt when you are about to do a wash,
as the dishwasher needs to be rinsed out immediately
after filling.
Proceed as follows the first time:
1. First unscrew the cover as illustrated.
2. Place the funnel, which is supplied with the
dishwasher, into the compartment’s filler hole.
3. First pour in approximately 1 litre of water. Then fill the
compartment with max 1.5 kg salt.
4. Wipe away excess salt so that the cover can be
properly screwed into place.
5. Run a Normal wash program so that any salt in the
machine is rinsed away.
When the salt runs out, the salt symbol on the display*
lights up. Unscrew the cover and fill the compartment
with salt. Water is only needed on the first occasion!
Wipe clean and screw back in place. Run a Normal wash
program so that any salt is rinsed away.
*NOTE!
After filling, there may be a short delay before the signal
light goes out.
WARNING!
Never pour dishwasher detergent into the salt compartment.
It will destroy the water softener!
Cover for the salt compartment
Open
Closed
Refill indicato
r
Cover for rinse aid
Open by turning and lifting the cover!