170687
Instructions for Use, Building- in and Connecting
9
Stubborn and burnt stains
are removed with
special ceramic-glass scraper. Be careful,
however, not to touch the hotplate surface with
the scraper handle (Fig. 4).
Handle the scraper with utmost care to avoid
injuries!
Sugar and sugar containing
food may
permanently damage the ceramic-glass hob
surface (Fig.5), so the remains of sugar and
sugar containing food must be scraped off from
the hob surface immediately, when the hotplates
are still hot (Fig. 4).
Discoloring of ceramic-glass hob
has no effect
whatsoever on its operation and stability. In most
cases, it appears as the consequence of burnt in
food remains, or as a result of dragging pots and
pans (especially aluminum or copper bottom
cookware) across the surface, and such
discoloring is rather hard to remove.
Note:
All described faults are mostly esthetical
and do not affect directly the operation of the
appliance. Remedy of such faults is not covered
by warranty.
Troubleshooting guide
Repairs may be done by qualified personnel only.
Any unskilled attempt to repair the appliance is
extremely dangerous.
Before attempting any repairs disconnect the
appliance from the mains by removing the fuse or
unplugging the mains lead from the mains socket.
Any unskilled attempts and/or repairs may cause
electric shock and short circuit. To avoid such
injuries any repairs may be performed only by
qualified personnel or after sales service.
Note
There are, however, some minor faults which
may be easily removed by the user, in
accordance with the instructions that follow.
Important
If the malfunction of the appliance was caused by
the
improper use
, the service visit during the
warranty period is
not free of charge
.
Keep these instructions always on hand and if
you sell the appliance hand them over to the
new user.
Following are some simple advice how to repair
minor faults:
Fault
Cause
Remedy
Burner flame is not steady.
Wrong setting of gas.
Expert should set the gas escape
properly!
Burner flame suddenly
changes.
Incorrect assembly of burner
components.
Assemble the burner components
correctly!
Ignition of burners takes
excessively long.
Incorrect assembly of burner
components.
Assemble the burner components
correctly!
The flame goes off after
ignition.
Early release of control button.
Control button is not pushed in
firmly.
Keep the button pressed longer.
Before releasing the button, give it
one final solid push.
The color of the cooking zone
gas grid has changed.
Normal situation, caused by the
high temperature.
Clean the grid with metal cleaning
agents.
Electric operations are
generally disturbed.
Fuse is burned.
Check the fuse in the fuse box, and
replace if required.
Electric ignition of burners
does not function.
Food residues or detergent block
the contact between the ignition
device and the burner.
Open and clean carefully the
opening between the ignition
device and the burner.
Burner crown caps look ugly.
Usual staining.
Clean the crown cap with metal
cleaning agents.
