EN 13
Maximum continuous operation of a particular
hotplate is limited, and the duration is displayed in
the above chart. When the hotplate is switched off
by the safety mechanism, the indicator displays
symbols ʺ0ʺ, or ʺHʺ in case there is any remaining
heat left.
Example:
Set the cooking zone to level 6 and leave
it to operate for a while. If the cooking zone setting is
not changed, the security mechanism will switch off
the zone after one and a half hour.
OVERHEATING SAFETY DEVICE
The hob is fitted with a cooling fan which cools
the electronic components during cooking. The
fan may operate for a while even after the end of
the cooking process.
Induction cooking hob is also fitted with a built-in
overheating protection device that protects the
electronic parts from damage. The protection
device operates at several levels. When the
cooking
zone
temperature
increases
considerably, the cooking power is reduced
automatically. If this is not enough, the power of
currently heated cooking zones is reduced further
or shut off entirely. In this case, ʺE2ʺ will be
indicated on the display. When the hob has
cooled down, entire cooking hob power is again
available.
TIMER
Select the timer by simultaneously pressing the
ʺ–ʺ and ʺ+ʺ sensor (E). Timer settings are
displayed on the upper two display units (H),
during which time the lower two display units are
switched off.
Timer setting is only displayed for 10 seconds;
then, the display switches back to power level.
YOU MAY CHOOSE TWO OPERATING
MODES
a)
Shut-off timer
– the timer function is connected
to the selected cooking zone. When the time
expires,
the
cooking
zone
is
switched
off
automatically.
b)
Minute minder
– timer function only has
warning/alarm functionality. When the clock runs
out, only an acoustic signal is emitted.
Activating and setting the timer
Select the timer by simultaneously pressing the
ʺ–ʺ
and
ʺ+ʺ sensor (E).
If you have previously selected a cooking zone so
that the corresponding display unit is lit more
intensively, then the timer will be set for that
cooking zone. The decimal point next to the
power level indicates that the timer has been
activated.
The timer (minute minder) can also be set when
no cooking zone is selected, if you wish to be
warned of something other than the cooking
process. Activated timer (or minute minder) will
be indicated with two flashing decimal points next
to the display unit.
Set the cooking time by pressing the
ʺ–ʺ or ʺ+ʺ
sensor (E). (Pressing
ʺ–ʺ first will set the timer to 30
minutes. If you press and hold the sensor, the
setting on the display will change at an increasing
rate.).
Value
can be set from 01 to 99 minutes. Shut-off
timer can be set for each cooking zone.
To check the
remaining time
, select
the
corresponding cooking zone and activate the timer
function. Press the
ʺ–ʺ or ʺ+ʺ sensor (E) to change
the setting. (Press the
ʺ–ʺ and ʺ+ʺ sensor (E)
simultaneously and sequentially to choose between
active settings.)
When the set time expires
,
ʺ00ʺ will flash on the
display; in addition, relevant decimal point will flash
at the shut-off timer. A short beep will be heard. To
acknowledge and stop the beep, press any key;
after 2 minutes, the beep will end automatically.
BRIDGE COOKING ZONES
(depending on the model)
Some models allow you to connect both left
cooking zones to create one bigger cooking zone
where you can place a large, oval pan. The pan
must be large enough to cover both centers of the
cooking zones.
Maximum baking dimensions: 40 cm x 25 cm. We
recommend to use a pan with thicker bottom.
