Gorenje Classico BO73CLB, Инструкция по эксплуатации

Страница: 40 / 44

425514
thus, the appliance can be connected before it is pushed to
the wall.
• The length of the power cord should be adjusted in such
way that in case of pulling load on the cable, the ground
wire is strained later than the voltage wires.
Procedure
• Use a screwdriver to open the cover of the connection
terminal on the back of the appliance. Release the two clips
as indicated on the cover of the connection terminal.
• The mains cord must be inserted into the strain release
device which protects the cable from being pulled out. If
the strain release device is not installed yet, install it in such
way that it gets stuck in the connection terminal housing at
one end.
• Then, connect the appliance according to the instructions
indicated on the fi gures. If network voltage is diff erent, the
connection bridges should be replaced.
• Firmly fasten the strain release device and close the cover.
Lead colors
L1 = external leads under voltage. Normally, the lead colors
are black, black, brown.
N = neutral lead, normally blue.
Make sure the N-lead is connected correctly!
PE = protection, or earth (ground) lead, normally green-
yellow.
40