GORAVE GOTV
AUDIO SENDER
Owner’s Operation Manual
V1.0 / 07-19-2016
MORE THAN MUSIC
6
will turn bright green – your Audio Sender has been saved in the Receiver’s Favorites List.
Finally, put your Receiver into the automatic “All Play” mode by pressing the Receiver’s Connect button four times. The LED indica
-
tor will turn red. When the Receiver is in All Play, you will not have to press the Connect button to play audio from your TV or other
paired Audio Senders. It will automatically play from the first Audio Sender that transmits.
5. TV INFRARED REMOTE SETUP
You can use your TV’s infrared remote control to increase the volume, decrease the volume or mute the audio through the GoTV Audio
Sender. Follow these steps to train your GoTV to listen to the volume and mute commands from your IR remote.
1. Get your IR remote ready.
1. Disconnect the USB power and audio input cables from the GoTV Audio Sender.
2.
Plug USB into a power source. The GoTV LED indicator will flash twice, ready to learn.
3.
Press the Volume ↑ button on the TV’s infrared remote. The GoTV LED indicator will flash once to confirm that Volume ↑ has been
learned.
4.
Press the Volume ↓ button on the TV’s infrared remote. The GoTV LED indicator will flash once to confirm that Volume ↓ has been
learned.
5.
Finally, press the Mute button once. The red LED will flash for 2 seconds to show that Mute has been learned and that the whole
procedure was a success.
6.
Now insert the 3.5 mm audio cable and start playing audio.
If GoTV senses that an audio cable is connected at power up, it continues in normal operation. GoTV will start the learning mode if it
is powered on with no audio cable inserted into its 3.5mm jack. To skip learning and use your previously learned IR commands, make
sure an audio cable is plugged into GoTV before connecting power.
You can disable infrared learning if you click the same button twice on your remote control during the learning procedure.
If at any point in the sequence, GoTV does not see a button press for more than 15 seconds, the LED will flash twice and infrared learn
-
ing will be disabled. If GoTV sees at least one button press and no second or third button press within 14 seconds, the LED will flash
four times and all previously learned IR commands will be erased. If GoTV sees the same button pressed twice in a row, the LED will
flash four times and all previously learned IR commands will be erased. Use steps 1 and 2 above again to restart the learning proce
-
dure.
GoTV will remember previously learned infrared commands even while powered off.
Connect Button:
Status:
LED Indicator:
Single Click
Playing or waiting to play from an Audio Sender on the
Favorite List.
(dim)
(bright)
= waiting
= playing
Double Click
Playing or waiting to play from an Audio Sender that has
not yet been added to the Favorite List.
(dim)
(bright)
= waiting
= playing
Hold
Add or remove an Audio Sender from the AR5 Favorite
List by pressing and holding the connect button for 4
seconds.
to
= added Favorite
(flash)
= deleted
4 Clicks
*RECOMMENDED: Put the Receiver into “All Play” mode
to play from any Favorite Audio Sender without manually
pressing Connect button each time.
(dim)
(bright)
= waiting
= playing
6 Clicks
Clear the Favorites List and reset volume settings.
(flash)
= list reset
