FIG.4:
The Pedals (pt.
81
& pt.
27
) are marked
"L" and "R" - Left and Right. Connect
them to their appropriate cranks. Note
that the Right pedal should be threaded
on clockwise and the Left pedal
anticlockwise.
FIG. A: Adjusting the Tension:
Increasing or decreasing the tension allows
you to add variety to your workout sessions by
adjusting the resistance level of the bike.
To increase resistance (requiring more
strength to pedal), turn the brake Knob to the
right.
To decrease resistance (requiring less strength
to pedal), turn the brake Knob to the left.
1.PREPARATION:
A. Before assembling make sure that you will have enough space around the
item.
B. Use the present tooling for assembling.
C. Before assembling please check whether all needed parts are available (at
the above of this instruction sheet you will find an explosion drawing with all
single parts (marked with numbers) which this item consists of.
2.ASSEMBLY INSTRUCTION:
FIG.1:
Attach the Front Stabilizer (pt.
21
) to the Main
Frame using two sets of Ø8 Flat Washer
(pt.
95
), M8 Domed Nut (pt.
93
)
Attach the Rear Stabilizer (pt.3) to the Main
Frame using two sets of Ø8 Flat Washer
(pt.
95
), M8 Domed Nut (pt.
93
).
FIG.2:
Put the Seat support tube (pt.
79
) into the seat
post tube on the Main Frame. Slacken the Knob
(pt.
90
) and pull the knob out to select the
desired height. Release and retighten the knob.
Use the Knob (pt.
80
) to adjust the seat front
and rear.
The Seat (pt.
77
) fixed on the Seat support tube
(pt.
79
), as shown, and lock the nuts under the
seat.
www.costway.com
www.costway.com
ASSEMBLY INSTRUCTION
FIG.1
FIG.2
FIG.3:
Put the Handlebar Post (pt.
53
) into the
FIG.3
handlebar post tube on the main
frame. Slacken and pull out the Knob
to select the desired height.
Release and retighten the knob to fix.
Fix the handle cover (pt.
49
) onto the
Handlebar with four sets of Spring
Washer (pt.
38
) and Bolt (pt.
39
). Slip
the monitor (pt.
4
7) onto the groove on
the handle cover and connect the
corresponding cables (Double wire for
Pulse in the right and single wire for sensor in the left).
ATTENTION: YOU SHOULD FIX THE HANDLEBAR TIGHTLY
FIG.4
FIG.A
