08
3.3.5 Main functions of SEC1000S
In the Grid Connection Diagram as shown in 3.3.4( quantity of Inverter can be more than one),
SEC1000S will have the functions of Active Power Regulation, and Back flow prevention, etc. The
corresponding parameters of the inverter are acquired and set through the software ProMate
installed in computer for monitoring and configuring SEC1000S. ProMate is a kind of software that
can configure Ezlogger Pro, SEC1000S etc. It can modify the network IP address of Ezlogger Pro
and SEC1000S, configure the number of connected inverters, time setting, RCR, DRED function,
configuration and on-site debugging. First, the user need to install "ProMate" in the computer by
downloading ProMate from Internet (http://www.goodwe-power.com/files/ProMate.rar), Please
access to the website to download the program and competethe installation. If the user needs to
use ProMate software to configure SEC1000S, it needs to be set in dynamic IP(DHCP) or static IP
according to the network connection mode.
(1)If the user is in the dynamic IP mode, he/she only needs to connect the SEC1000S NET port to the
Router LAN port with the network cable to connect to the network, namely plug and play.
(2)If the user has a static IP, it is necessary to switch SEC1000S to the static IP mode. That is, press
the Reload key for about 10 seconds to reset and restart SEC1000S, About 10 seconds after pressing
the Reload button, the LED lights on the SEC1000S internal EzLogger Pro Panel will blink from right
to left and reset and restart.
After restart, SEC1000S will be switched to static IP mode(default IP:192.168.1.200), then use cables
to connect SEC1000S“NET” port to the Ethernet port of the computer.At the same time, the IP
address of the computer needs to be modified. The IP address and the default gateway should be
set at 192.168.1.xxx segment (1 ≤XXX ≤250 and XXX ≠200). For example, the IP address can be set
as 192.168.1.100 and the default gateway as 192.168.1.254.
The interface of Promate is as follows:
On “COM Configuration” part, you should enter the number of inverter connected to each
communication port of SEC1000S. For example, you should enter “3” if there are 3 pieces of inverters
communicate to COM1, enter “2” if there are 2 pieces of inverters communicate to COM2.
