BIOSPRAY®-10C 1020
5
INSTALLATION/SETUP
1. Remove from packaging and inspect unit. If anything is damaged, contact
Goodway Technologies immediately (800-333-7467).
2. Place the surface sanitization system on a flat surface.
Installing the CO
2
Tank (BioSpray®-10C):
1. Open the rear door
4. Attach the top and bottom strap and
tighten until tank is snug and cannot
move.
5. Tightly connect the hand nut to the
CO
2
tank.
2. Detach and loosen both straps that
will hold in the 10 lb. CO
2
tank
3. Carefully install new tank against
brackets, on top of rubber pads on
left hand side of the unit. Make sure
the connector on the tank is facing to
the right.
6. Close the rear door and latch the
door.
