5
RADIO OPERATION
Set FUNCTION SWITCH to “RADIO” position.
FM/FM ST. BAND
Select FM ST. mode by band selector switch. Turn the TUNING control to select the desired station. The FM
stereo indicator will light up which shows a FM stereo broadcast is being received, fully extend the FM antenna
and adjust its direction for best FM reception. If the FM broadcast signal is weak, slide the switch to “FM” position
to turn off the FM stereo, FM stereo indicator will disappear and the background noise will be reduced. After use
set the function selector switch back to Off/Tape position.
MW BAND
Select MW mode by band selector switch. Turn the TUNING control to select the desired station. The MW aerial
is fitted internally and is highly directional. Rotate the set for best reception. After use move the function selector
switch back to the Off/Tape position.
CASSETTE OPERATION
PLAYBACK OF CASSETTE
Be sure to tighten any slack tape in the cassette before use, using either a pencil or a ballpoint pen, simply insert
the pen or pencil into the centre of spool and rotate to remove slacks. Depress the STOP/EJECT button to open
the cassette door.
Insert the cassette into the compartment with the open end facing upwards and the full reel on the left hand side,
push the cassette well down and close the door, be sure not to touch the tape surface, Set the Function switch to
“TAPE” position and press the cassette play button. To stop playback, press the STOP/EJECT button once. To
release the cassette, press the STOP/EJECT button again.
AUTO STOP
When the tape reaches the end during playback or recording, the built-in auto stop system will release the
depressed play, record keys. The auto stop system operates while recording from the built-in radio or CD player,
only the cassette function is brought automatically to stop mode and the radio or CD player will continue to play.
RADIO RECORDING
A.
Install blank cassette tape.
B.
Set FUNCTION SWITCH to “RADIO” position. After selecting the desired band and tune the TUNING
KNOB to desired broadcast station. Then push down RECORD BUTTON and PLAY BUTTON simultaneously.
C.
After recording the desired broadcast, depress the STOP/EJECT BUTTON lightly, and then set FUNCTION
SWITCH to “TAPE” position in order to listen to the recorded broadcast.
D.
Press REW button then play button to playback your recording.
ERASURE: When you record over previously recorded tape, the original recording is automatically erased and
replaced by the new recording.
CD/MP3 RECORDING
A.
Install a blank tape into cassette compartment.
B.
Set the FUNCTION switch to “CD/MP3” position. Load a disc into the disc compartment, start playback by
pressing the CD PLAY/PAUSE button after the unit finished reading the disc.
C.
Depress the RECORD BUTTON and PLAY BUTTON simultaneously. Recording starts. Press the STOP/EJECT
BUTTON lightly to end recording, or the unit will stop recording automatically while the tape reaches its end.
D.
To listen to the recording, set the FUNCTION switch to select “TAPE” playing mode, then start tape playback.
RECORDING FROM BUILT-IN MIC
1.
Set the Function Switch to "TAPE" normal position.
2.
Insert a blank cassette tape into the tape deck.
3.
Press the RECORD key and the PLAY
key simultaneously. You can start the recording through the built-in MIC.
4.
To stop the recording manually, press the Stop/Eject Button.
