Goodman GPG16 M Series, Руководство по установке

Страница: 7 / 32

7
5
6-3/16
7-3/8
SUPPLY
12" X 17"
RETURN
11" X 25"
H
oRIZontal
d
IScHaRGE
d
Uct
c
onnEctIonS
RIGGING DETAILS
WARNING
t
o PREvEnt PRoPERty daMaGE
,
tHE UnIt SHoUld
REMaIn In an UPRIGHt PoSItIon dURInG all RIGGInG
and MovInG oPERatIonS
. t
o facIlItatE lIftInG and
MovInG WHEn a cRanE IS USEd
,
PlacE tHE UnIt In an
adEqUatE cablE SlInG
.
CAUTION
I
f UnItS aRE lIftEd tWo at a tIME
,
tHE foRk
HolES on tHE condEnSER End of tHE UnIt MUSt
not bE USEd
. M
InIMUM foRk lEnGtH IS
42”
to
PREvEnt daMaGE to tHE UnIt
;
HoWEvER
, 48”
IS
REcoMMEndEd
.
P
RovISIonS foR foRkS HavE bEEn InclUdEd In tHE
UnIt baSE fRaME
. n
o otHER foRk locatIonS aRE
aPPRovEd
.
WARNING
t
o PREvEnt PoSSIblE EqUIPMEnt daMaGE
,
PRoPERty
daMaGE
,
PERSonal InjURy oR dEatH
,
tHE folloWInG
bUllEt PoIntS MUSt bE obSERvEd WHEn InStallInG
tHE UnIt
.
• Unit must be lifted by the four lifting holes located at
the base frame corners.
• Lifting cables should be attached to the unit with
shackles.
• The distance between the crane hook and the top of
the unit must not be less than 60”.
• Two spreader bars must span over the unit to prevent
damage to the cabinet by the lift cables. Spreader
bars must be of sufficient length so that cables do
not come in contact with the unit during transport.
Remove wood struts mounted beneath unit base
frame before setting unit on roof curb. These struts
are intended to protect unit base frame from fork lift
damage. Removal is accomplished by extracting the
sheet metal retainers and pulling the struts through
the base of the unit. Refer to rigging label on the unit.
I
MPoRtant
: I
f USInG bottoM dIScHaRGE WItH Roof
cURb
,
dUctWoRk SHoUld bE attacHEd to tHE cURb
PRIoR to InStallInG tHE UnIt
. d
UctWoRk dIMEnSIonS
aRE SHoWn In
R
oof
c
URb
I
nStallatIon
I
nStRUctIonS
.
Refer to the Roof Curb Installation Instructions for proper
curb installation. Curbing must be installed in compliance
with the National Roofing Contractors Association Manual.
To assist in determining rigging requirements, unit weights
and center of gravity are shown as follows:
WEIGHTS AND CENTER OF GRAVITY
Y
X
CG
COMPRESSOR
CONDENSER COIL
RETURN
EVAPORATOR COIL
B
C
D
A
SUPPLY
Corner and center of gravity locations