Golz FS 240 SE, Руководство по эксплуатации

Страница: 15 / 47

FS 240 SE
Operating instructions
- 15-
02822410998
5006580-00
5.1 Mounting the blade
In the cutting speed range all used blades must be designed for the max. rpm of the machine. Never
use faulty or damaged blades.
Danger: Damaged cutting discs can cause serious personal injury!
Note: Wrong direction of rotation leads to drastically increased wear of the cutting disc!
Danger: Wrong direction of rotation can result in the detachment of a segment of the
cutting disc and thus cause serious personal injury!
Depending on the material to be machined, the machining process and the nature of work to be
carried out, use the cutting discs according to manufacturer's / supplier's specifications.
Note: Before mounting the cutting disc, thoroughly clean all the fastening ele-
ments relating to the cutting disc such as flanges, threads of the cutting shaft,
screws or nuts!
Each time a cutting disc is mounted or changed, the joint cutter is to be shut down first and the
emergency stop switch is to be pressed or to be disconnected from any energy source.
Pull out the spring cotter pin (Pos. 2) so that you
can remove the cutting disc guard (Pos. 1) from
the machine. Clean the inner flange (3) before
mounting the blade.
Mount the cutting disc (max. Ø 800 mm, Pos. 4) with the correct
mounting holes (Ø 25.4 mm)
Make sure that the rotational direction is correct! There are
directions of rotation arrows on the cutting disc guard as well as
on the cutting disc itself.
Fit the outer cutting flange (Pos. 5) and secure it with screw M
16 (Pos. 6) SW 24.
In the cutting shaft, there is a left-hand thread in the direction of
motion on the right; in the direction of motion on the left, there is
a right-hand thread.
6
5
4
1
3
2