93
With the door release push button pressed, pick up
the telephone's handset
.
.
P
rogramming the telephones
To show that the system is ready for programming, the
door panel and handset will reproduce a tone, and audio
communication can be established
door release push button can be released
.
The
.
Press the door panel push button that
will call to this telephone
At this moment both door panel
and handset will reproduce tones
.
.
L
.
.
ocate the configuration dip switch situated under the protection
cover of the EL500/V2PLUS microprocessor circuit and set
number 2 to ON as described on page 83
The door panel will reproduce a sound to advise that the
system has entered into programming mode
Each apartment must have one master unit only; if there is a parallel unit, be it a monitor
or telephone, it must be configured as slave.
Make a call to check that the telephone has been successfully programmed
Repeat these steps to program the rest of telephones
Once the programming has finished, set the programming switch to
If you don't, the door panel will reproduce a sound to advise that the
system is still into programming mode
.
.
OFF.
.
TELEPHONES PROGRAMMING
94
.
E
xternal lock release activation
The lock release can be activated at any moment by using an external push button, that must be
connected between
of the door panel
This function will allows to exit from the building being not necessary the use of a key
'CV1' and 'CV2'
.
.
CV1
CV2
EL 500/V2PLUS
OPTIONAL CONNECTIONS
BUS HZ
PA
S+
HZ
PB
S-
oor bell push button connection.
D
The
monitors and the
telephones, incorporate as standards the
call reception from the door bell push button. This feature spares the use of a bell, by placing a
push button between the "HZ" monitor or telephone terminals
The reproduced acoustic tones are different depending on their provenance, that allows the
user to distinguish where the call is made from If during a conversation a call is made from
the apartment door, acoustic tones will be reproduced on the handset to advise that someone
is calling
Platea V2Plus
T-7822VD
.
.
.
T-7822VD
Platea V2Plus
BUS IN
PA PB
BUS OUT
HZ
BUS E.of.line
Master
Slave
1
2 Slave
To program the telephone as master, replace the handset
To program it as
Slave press the lock release push button
once. After the door panel and handset reproduce a short tone,
replace the handset If a long tone is reproduced then an error
has occurred; reconfigure the telephone
.
1
.
.
To program it as
Slave press the lock release push button
twice. After the door panel and handset reproduce two short
tones, replace the handset If a long tone is reproduced then
an error has occurred; reconfigure the telephone
2
.
.
double
click
st
st
nd
nd
