6
TEKNA PLUS SE MONITOR
The monitor features an RJ-45 connector for installation with a UTP
cable. It is located on the left-hand side of the back of the monitor.
It enables connection of the system's main communication wires
(+, -, A, D, Vp y Mp)
.
in twisted-pair installations
RJ-45 connector (cable type: T568B)
Male connector
Female connector
PA R 2
I
PA R 1
I
PA R 4
I
PA R 3
I
1 2 3 4 5 6 7 8
1 2 3 4 5 6 7 8
Ethernet cable Golmar connection
White + Orange
GND (Audio)
Audio
GND (Dat )
a
+18V
+18V
Data
Vp
White + Brown
Mp
RJ-45 equivalence table
Description of the RJ-45 connector (installation with UTP cable):
Pin
1
2
3
4
5
6
7
8
Orange
White + Green
Blue
White + Blue
Green
Brown
Locate the CN4 connector at the back of the monitor.
To insert the EL562 module, remove the jumper that is in the connector.
NOTE:
In this type of installation, set the SW1-3 DIP switches on the sound module of the
door panel to ON, see instruction manual
(page 13), or the SW1-3 DIP
T632/Plus ML
switches on the EL500SE microprocessor to ON, see manual
(page 7). The
T5000 ML
door panel of the SV801SE GRF kit does not require modification.
Use the specific wiring diagram.
The end of line jumper is located on the CN4 connector at the back of the monitor.
In the case of twisted pair installations, the end of line jumper is located in the EL562
module (see next section).
Do not remove the jumper if the video cable ends in the monitor. Remove the jumper if the
video cable continues after the monitor.
DESCRIPTION OF THE MONITOR
MONITOR ADJUSTMENTS
Handling of the end of line jumper:
EL562 module for video door entry system installations with twisted pair cable:
