OPTIONAL CONNECTIONS
16
TEKNA PLUS SE MONITOR
A
_
+
D
Mesh
V
in
V
out
CN4
If the television or video has a SCART socket, an image of the caller can be displayed on the television screen via
the auxiliary channel.
Remove the 75-ohm end-of-line jumper resistor located on the CN4 connector on the back of the monitor. Connect
the coaxial cable to terminals 17 (mesh) and 20 (live) of the SCART connector.
Intercom between two points in the same apartment:
A
_
+
D
INT
Mesh
V
in
V
out
CN4
The Tekna Plus SE monitor features as standard an intercom function between two points in the same apartment.
To enable this feature, the following is necessary:
-
One of the monitors needs to be configured as master and the other as slave with intercom, as described on
page 9. In the case of intercom between a monitor and a telephone, it is recommended to configure the
monitor as the master.
-
The INT terminal of the intercom devices need to be connected (see diagram attached).
To use the intercom function to call all of the monitors in the apartment, lift the handset and press the button until a
confirmation tone can be heard. To call individual devices, press the button once to call the master monitor,
"
"
twice to call slave 1 , 3 times to call slave 2 , 4 times to call slave 3 and 5 times to call slave 4 . This selective
"
"
"
"
"
"
"
"
intercom call mode is only available with the Tekna Plus SE monitor. This only functions if no call or
communication is in progress. A number of audible tones emitted by the handset will confirm that the call is being
made or that the unit being called is in communication with the door panel. To establish communication, lift the
handset of the unit being called. If a call is received from the door panel during an intercom process, the handset
of the master unit will emit a number of audible tones and an image will appear. To establish communication with
the door panel, press button
on the unit configured as master or press the door release push button to simply
open the door.
The ringtones vary depending on where the call is made from to enable the user to identify its origin.
Note:
If the apartment also has Tekna Plus monitors, the Tekna Plus SE monitors must be configured as Intercom
"
with Tekna Plus monitors (see page 12). This configuration mode does not allow selective intercom calls to
"
different monitors in the apartment; when the intercom button is pressed, all of the monitors in the apartment will
receive the call.
Tekna Plus SE
A
_
+
D
INT
Mesh
V
in
V
out
CN4
Tekna Plus SE
Connection of the Tekna Plus monitor to a television or video:
Tekna Plus SE
Continued overleaf
Continued from the previous page.
