8
MONITOR SETTINGS
The
DIP switch is located on the left-hand side of the back of the monitor. It enables
SW2
the monitor to be configured as master/slave.
SW1
1
2
3
4
5
6
7
8
1
2
SW2
SW1
S
2
W DIP switch:
INT
: Internal code of the monitor/telephone to set as master/slave.
Set the monitor/telephone as master, slave 1, slave 2 or slave 3 using the SW2 DIP switch with a
code from 0 to 3 respectively. Taking into account the following points:
In the case of a single monitor/telephone in the apartment, the code to be set will always be 0.
In apartments, up to 4 monitors/telephones can be connected in parallel, all with the same user code but with
different internal monitor/telephone code.
The internal code serves to identify each of the monitors/telephones in the same apartment. This enables
intercom calls to be made to a specific monitor/telephone in the same apartment. In the case of intercom calls to
different apartments, and in the case of calls coming from door panels and from apartment front doors, all of the
monitors/telephones in the apartment always sound. The following considerations must also be borne in mind:
When master monitor/telephone 0 receives a call, it sounds immediately and slave monitors/telephones 1, 2 and 3
sound in succession, one after the other.
If a call is made from a video door entry panel, master monitor/telephone 0 shows the image of the door panel.
During the call time (60 seconds) and before establishing communication, the other slave monitors in the same
apartment can capture the image of the door panel if button
is pressed, causing the image on the monitor that
was displaying it to disappear.
2
1
INT 1
ON
2
1
INT 0
ON
2
1
INT 2
ON
2
1
INT 3
ON
*
( )
Factory setting.
*
( )
S 2 DIP SWITCH:
W
El569 IN/OUT UNIT:
The EL569 In/Out unit must be inserted in all of the intermediate monitors and the J4 end of line jumper must be left
inserted in the last monitor.
1
2
3
4
5
6
7
8
1
2
1
2
3
4
5
6
7
8
1
2
EL-569
J4
1
2
TEKNA GTWIN MONITOR
