golmar SV-372S Colour, Инструкция по эксплуатации

Страница: 11 / 24

49
unction push buttons.
F
MONITOR DESCRIPTION
witch 'end of line resistor'.
S
The switch 'end of line resistor' is located
. Place
.
at the left side of the back of the
monitor to ON the monitor where bus wires terminate, set to OFF only
for intermediate monitors
*Factory default
Push button to stablish / finish communication or intercom function (only available on systems
with 2 or more monitors in the same apartment, for description and connection see page
52, 55 & 57).
In configuration menu mode: To scroll up through the menu or to increase the value of the
selected option, (see page 53).
Push button for a It allows to visualize the picture and to listen the audio with the
door paneI during 90 seconds (if exists more than one door panel, pushing each time, the
picture and audio will switch from a door panel to the other one), to establish audio and
video communication with the door panel
In configuration menu mode: To scroll down through the menu or to decrease the value of the
selected option, (see page 53).
Push button to activate the lock release. During call reception, communication and
autoswitch-on processes, it allows lock release activation. During activation, the picture
will disappear from the monitor screen.
In configuration menu mode: Select / deselect the desired option, (see page 53).
Push button to activate the auxiliary device. D
, activate the auxiliary device (see page 59).
utoswitch-on.
press push button. The communication will
last for 90 seconds or until press push button monitor again.
uring call reception, communication and
autoswitch-on processes
Push button to enter / exit the configuration menu mode (see page 53).
50
MONITOR INSTALLATION
emove the bracket installation.
R
Unscrew the monitor bottom screws.
Remove the bracket installation of the monitor.
ix the bracket installation to the wall.
F
Avoid to place the monitor near to heating sources,
in dusty locations or smoky environments.
The bracket can be fixed using an electrical emmbeding
box or directly on the wall. To install directly over the
wall, drill two holes of 6mm. and use the supplied
screws.
The upper part of the bracket must be placed at 1,60m.
height roughly. The minimum distance between the
monitor and the closest object must be 5cm.
+
BUS
OUT 1
2
BUS
IN 1
2
Vcc
+
BUS
OUT 1
2
BUS
IN
1
2
Vcc