SYSTEM CHARACTERISTICS
O
O
O
O
O
O
3.5" TFT colour screen.
Menu and OSD messages on screen.
Management of up to 255 internal buildings of 1,000 apartments each.
Up to 2 porter's exchanges in one system.
New programming menu structure.
Direct Call Code that allows to use a different call code from the one recorded on the monitor or
telephone (page 49).
'Insert resident' function, that allows to keep sorted the repertory content (page 52).
Text edition using the keypad as a mobile phone (page 54).
It allows to activate/deactivate the clock battery using the menu, (factory default: deactivate).
Intercom function between 2 porter's exchanges.
New MEMEDIT software "Ver. 4.0" for USB connector, that allows to program porter's exchange
using a computer.
Compatible with previous porter's exchange CE-990 Plus.
O
O
O
O
O
O
Important:
Necessary USB communication printer cable (USB-A Male to
USB-B Male), is not supplied with the equipment.
NOTES FOR SYSTEMS WITH DOOR PANELS
3
O
O
O
Monitors and telephones should be programmed from the door panel, as it's explained on the
corresponding instruction manuals. Once the programming is done, make a call from each
apartment to the porter's exchange: the display will show the assigned code.
Use this instructions manual to program the porter's exchange and for system wiring purposes.
Refer to the door panel instructions manual for troubleshooting hints.
On systems with general entrance door panel(s), the porter's exchange(s) must be also general
(common to all the internal buildings). Consequently, the porter's exchange cannot be connected
in a internal building (for privated use of the internal building), as it's shown on the schematic
diagrams (pages
to
.
O
67
70)
O
O
O
O
w
w
w
w
w
O
w
w
w
O
O
Install or modify the equipment
.
The installation and handling of these equipments must be performed by
.
The entire installation must be at least
. away from any
.
With power supply:
Do not use excessive force when tightening the connector screws.
Install the power supply in a dry and protected place without risk of drip or water projections.
Avoid to place it near to heating sources, in dusty locations or smoky enviroments.
Do not block ventilation holes of the unit so that air can circulate freely.
To avoid damage, the power supply has to be firmly fixed.
To avoid an electrical shock, neither remove the protection cover nor handle the connected wire in
the terminals.
Porter's exchange:
Do not use excessive force when tightening the connector screws.
Install the porter's exchange in a dry and protected place without risk of drip or water projections.
Avoid to place it near to heating sources, in dusty locations or smoky enviroments.
Do not block ventilation holes of the equipments so that air can circulate freely.
Remember, the installation and handling of these equipments must be performed by authorized
personnel and in the absence of electrical current.
Do always follow the enclosed information.
without the power connected
authorised personnel
other installation
40 cm
w
w
SAFETY PRECAUTIONS