34
SYSTEM CHARACTERISTICS
OPERATION MODES
O
V2Plus
Ü
V2Plus
Ü
V2Plus
O
O
O
Up to 120 elements
apartments per installation or
backbone with 4 risers (being necessary the use of multiplexer
MC-V2Plus
).
O
Up to 480 elements
apartments per installation or
backbone with 16 risers (being necessary the use of multiplexers
MC-V2Plus
connected in daisy chain)
or 250 apartments with coded panel (it also needs
CD-V2PLUS/TP
converter).
O
O
O
O
O
V2Plus
O
V2Plus
O
O
O
Protocol converter for the
system which permits the following functions:
Permits the installation of Plus general door panels with the
system.
Permits the installation of a Plus coded door panel with
monitors.
Up to 250 converters per installation.
Up to 32 apartments and 32 elements (monitors, telephones or call repeaters) per backbone.
Simple configuration through easy access dip switches.
Autodiagnostic LEDS that allow detecting installation and/or programming errors.
Connection block for the Plus system with 4+TP installation.
Transceiver module
EL564
to convert the coaxial connection to twisted pair.
A multiplexer is required to place the
door panel between the converter and the monitors/telephones.
The
V2Plus
door panel must have the microprocessor circuit
EL500/V2Plus
installed, with
version
2.00
or later, for its compatibility with the protocol converter and the
MC-
multiplexer.
Permits the installation of a porter's exchange only on the side of the installation with the Plus system.
Maximum distance between the power supply and converter: 50m, with a wire section of 1.5mm.
Use Golmar
RAP-2150
cable in the
V2Plus
system.
(monitors, telephones or call repeaters) and 120
(monitors, telephones or call repeaters) and 120
Transceiver module for video signal.
The transceiver module for video signal
EL-564
converts the
coaxial to twisted pair and vice versa. This module is necessary in
a
V2Plus
system with a Plus coded panel or Plus general door
panels with a
3+Coax
installation and convert the coaxial to
twisted pair, and therefore connect the video signal in the
CD-
V2Plus/TP
protocol converter of the entrance twisted pair.
Installation diagram on pages 45-46.
CD-V2PLUS/TP
FA-V2PLUS
2
2
2
1
5
9
2
6
0
3
7
C
4
8
Central de conserjería
Porter's exchange
0
0
C
ancel
C
ancel
7
7
8
8
9
9
1
1
2
2
3
3
4
4
5
5
6
6
o.k.
o.k.
Lock release
3 + Coax
Porter’s
exchange
2
Platea V2Plus Monitors
2
2
2
2
Max. 32 apartments
FA-PLUS/C
Plus coded door panel
3 + Coax
4 + TP
EL-564
2
M
M
SAFETY PRECAUTIONS
O
Install or modify the equipment
without the power connected
.
O
The installation and handling of these equipments must be performed by
authorised personnel
.
O
The entire installation must be at least
40 cm.
away from any
other installation
.
O
Do not use excessive force when tightening the connector screws.
O
Install the unit in a dry and protected place without risk of drip or water projections.
O
Avoid to place it near to heating sources, dusty locations or humid enviroments.
O
Do not block ventilation holes of the unit so that air can circulate freely.
O
To avoid damage, the converter has to be firmly fixed.
Continue
