82
Ter, – and Malla (shield) are duplicated for easiest cascade installation of parallel
monitors or telephones. If the first monitor is not placed on the connector, cascade units
will not be powered.
escription of the RCTK-PLUS
D
monitor connector.
a. Wall attachment hole (x6).
b. Monitor attachment hook (x2).
c. Vertical wiring input.
d. Attachment clip.
e. Wiring input hole.
f. Installation terminals:
positive, ground.
video signal coaxial input.
coaxial shield.
video signal coaxial output.
audio communication.
digital communication.
door bell push button input.
intercom.
auxiliary calling device output.
video distributor activation output.
2nd camera activation output.
optional device activation output.
twisted pair video signal.
+, –:
Vin :
Malla:
Vout :
A :
D :
HZ- :
INT :
SA :
CTO :
2C :
A1 :
Vp, Mp :
MONITOR CONNECTOR DESCRIPTION
81
l562
E
twisted pair cable.
module for video installations with
andling the end of line jumper.
H
MONITOR ADJUSTMENTS
The monitors included in kits /SC come with the El562 module plugged
in the CN4 connector, that's placed in the monitor base.
NOTE: on this type of installations the EL500SE microprocessed circuit
must be setting with SW1-3 to ON (page 75). Refer to the specific
installation diagram.
The end of line jumper is placed on the CN4 connector, that can be
located on the monitor base. In case of twisted pair cable
installations, the end of line jumper is placed in the El562 module,
also located in the CN4 connector of the monitor base.
Do not remove the jumper on monitors where the video cable finish.
Remove the jumper on monitors where the video cable continue.
a
a
b
b
f
e
d
c
