Goldwing RC 77in CORVUS 35CC & 170E, Инструкция по эксплуатации

Страница: 44 / 47

Cut the wing film needed to be install the SFG. Fixed the SFG Use M3X18 hand bolts and balsa sheets.
Installation of the SFG is optional.
5. Fill your fuel tank making sure your vent line is not plugged or capped. With the canopy off, this is a good
time to check for any fuel leaks.
6. Check all control surfaces for secure hinges by performed a slight tug on the control surfaces and observing
if there is any give in the hinges. Check all control rods, ball links, servo screws, etc. for correct operation and
installation.
7. Check your batteries and perform a range check once again with the engine off and running. Be sure all
surfaces are moving in the correct direction and the correct amount for your flying setup.
8. You are now ready for your maiden flight! Good luck and enjoy your new aircraft! If you have any
comments or questions about this manual or the aircraft please email
service@goldwingrc.com
.
Recommend Accessories
（
Not included
）：
*
KUZA Twisted 22 AWG Servo Extensions
Two to three 12”(305mm) No. KAG002522 Two to three 24”(610mm) No. KAG002524