Goldwing RC 77in CORVUS 35CC & 170E, Инструкция по эксплуатации

Страница: 21 / 47

4. The CORVUS can use either closed loop or a rear push pull servo for the rudder. We recommend that you
balance the model assembled before choosing your servo placement.
5. The CORVUS is supplied with a high quality set of pull-pull cables and ball-links.
6. Install your rudder servo into the precut locations in the fuselage. Using a fine drill pre-drill the holes and
drop thin CA into the holes to strengthen the wood. You will need 3 inch arms on the servo. Set up your radio
accordingly and center the rudder servo.
7. The CORVUS has the closed loop pre-installed and crimped at the rudder end. These can be connected with
the M2.5 bolts and nut. The wire will be left looped inside the fuselage and will need to be connected to the
servo arm.