Goldstar MA-1303BRV, Руководство по обслуживанию

Страница: 10 / 18

5-6
K. HIGH VOLTAGE
TRANSFORMERREMOVAL
1) Discharge the high voltage capacitor.
2) Disconnect the leadwire from magnetron, high
voltage transformer, and capacitor.
3) Remove the screw holding the high voltage
transformer to the baseplate.
J. FAN MOTOR ASSEMBLY REMOVAL
1) Discharge the high voltage capacitor.
2) Disconnect the leadwire from magnetron, high
voltage capacitor.
3) Remove the two screws holding the the suction
guide ASS’Y to the oven cavity and remove the
high voltage diode earth screw.
4) Remove the two screws holding the fan motor
ASS’Y to the suction guide ASS’Y.
K. HIGH VOLTAGE CAPACITOR AND
DIODE REMOVAL
1) Discharge the high voltage capacitor.
2) Disconnect the leadwire from fan motor and high
voltage capacitor.
3) Remove the screw holding the suction guide ASS’Y
to the oven cavity and remove the high voltage
diode earth screw.
4) Remove the screw holding the high voltage
capacitor bracket.
L. INTERLOCK SYSTEM
1) INTERLOCK MECHANISM
The door lock mechanism is a device which has
been specially designed to eliminate completely
microwave activity when the door is opened during
cooking and thus to prevent the danger resulting
from the microwave leakage.
L. INTERLOCK SYSTEM
1) INTERLOCK MECHANISM
The door lock mechanism is a device which has
been specially designed to eliminate completely
microwave activity when the door is opened during
cooking and thus to prevent the danger resulting
from the microwave leakage.
2) MOUNTING OF THE PRIMARY/MONITOR/
SECONDARY SWITCHES TO THE LATCH
BOARD
3) INSTALLATION AND ADJUSTMENT OF THE
LATCH BOARD TO THE OVEN ASSEMBLY
• Mount the latch board to the oven assembly.
• Adjust the latch board in the arrow direction so
that oven door will not have any play in it when
the door is closed.
• Tighten the mounting screw.
• Check for play in the door by pushing the door
release button. Door movement should be less
than 0.5 mm. (1/64 inch)
Don't push the door release button while making
adjustment. Make sure that the latch moves
smoothly after adjustment are completed and that
the screws are tight. Make sure the primary,
monitor, and secondary switches operate properly
by following the continuity test procedure.
H.V.
Transformer
Suction
Guide
Noise Filter
H.V.
Diode
H.V.
Capacitor
Fan Motor
ASS’Y
PRIMARY
SWITCH
ADJUSTMENT
DIRECTION
MONITOR
SWITCH
SECONDARY
SWITCH