4
4 - CONNECTIONS
Connect the power cord to the back of the unit and plug it into the nearest wall plug.
Use a 3 lugs grounded plug for safety.
To get the best sound of the amplifier, avoid any multiple plug or extension cord.
Connect the interconnects between the sources and the amplifier. Plug the cables to
the RCA female sockets noted input 1 to 5. Connect the tape machine to TAPE IN
and TAPE OUT input and output RCA plugs.
Connect the speaker cables to the red and black terminals accessible in the back of
the amplifier.
You may notice that the ground of the input plug and the black speaker terminal are
the same polarity. The amplifier is non-inverting in phase.
5 - AMPLIFIERS CONTROLS
- POWER
On the back panel of the GOLDMUND SRI2 amplifier you will find the POWER key,
used to power the amp on.
After a very short delay the two channels are connected and the POWER led
switches on.
The amp may be powered off by turning off the POWER key at any time. The led will
fade very slowly, indicating discharge of the filtering.
- VOLUME
Level adjustment acting simultaneously on both channels (see also Remote-Control
below).
- MUTE
The right switch turns off the signal of the amplifier, without disconnecting the power
supply. It can be used to turn temporarily the volume down without touching the
volume control.
