GOLDMUND MIMESIS 11 – WIRELESS HUB - 6
1
SETTING UP THE MIMESIS 11 HUB (Ctd.)
1.5
FIRST INSTALLATION & CONNECTIONS
Wiring:
Connect the power cord to the back of the Mimesis 11 Hub and plug it into the nearest wall
plug. For safety reasons, use only a 3 lugs grounded plug. To get the best sound from the
Mimesis 11 Hub, avoid any multi-way plugs or extension cords.
Connect a computer, CD/DVD or Blu-ray player to the back panel of the Goldmund Mimesis
11 Hub, using either the USB Audio, Toslink Optical, RCA Digital or RCA Analog connector.
Only one connection per input can be used at once.
Select one of the 4 available inputs for listening using the front input selector or using the
remote controller.
Please contact your authorized Goldmund retailer to assist you to set up your computer for
use with the Mimesis 11 Hub.
When the input source is selected, connect your Mimesis 11 Hub output to your digital
amplifier/active speaker or your active wireless speaker using either one of the four stereo
RCA digital outputs or using the wireless audio stream (maximum 4 speakers). All RCA
output and Wireless output are in parallel.
Wireless:
The Mimesis 11 Hub and the associated wireless speakers must be paired. This means that
your Hub can only function with the speaker that is paired with it.
Please contact your official Goldmund representative where you purchased your unit to
install your Mimesis 11 Hub in a Wireless system.
NOTE
A USB driver needs to be installed on
your computer before to use it as a
source with your unit. Mac and Linux
operating system do not need driver
to be used with the Mimesis 11 Hub.
ATTENTION
A residual high frequency noise may
remain
audible
in
some
circumstances if an analog input is
left open and is selected. This
disturbance has no effect on the
amplifier but may be avoided easily
through the application of short-
circuit plugs on all unused inputs.
