d.
Plug the power supply’s output connector into the mating connector on the
back of the wireless remote display/keypad.
e.
Reattach the wireless remote display/keypad to the baseplate.
f.
Plug the power supply into a 120VAC outlet.
Installation - AQL-Tx-RF-PS-x Table Top models
1.
Base Receiver required:
For operation of the AQL-Tx-RF-PS-x, the Aqua Logic
control unit must have a base receiver (AQL-BASE-RF) installed. The receiver
also allows the Aqua Logic control unit to communicate with an optional spa-
side remote.
2.
Select Location:
Because the AQL-Tx-RF-PS-x is battery operated and de-
signed to be portable, there are no power supply or mounting concerns like the
Wall Mount units. The Table Top units are intended to be used in the normal
living space, with these considerations:
Protected from the weather:
The wireless remote display/keypad should be
used indoors or in a weather protected area (rain should never hit the wire-
less remote display/keypad). Understand that areas that protect the unit
from rain, may still allow condensing humidity (dew, mist, fog, etc.) which
can damage the AQL-Tx-RF-PS-x over time. Because the unit is portable and
may be used in different areas around the pool and home, it's important to
understand that it is NOT water resistant and can be easily damaged if used
in the wrong manner.
Within range of Base Receiver:
The wireless remote display/keypad must
be used within 200 ft. (assuming the signal will have to travel through walls)
or 400 ft. (line of sight) from the Base Receiver which is typically mounted on
2
Pull up on bottom edge
to remove cover
Wireless Remote
Display unit
