Heater ON/OFF
Provided that the filter pump is running, normal Aqua Logic
operation will turn the heater on until the desired temperature
(see Settings Menu) is attained. The heater will then turn on
periodically, as required, to maintain that temperature. When
the ON button is pushed, the heater will turn on for a minimum
of 5 minutes or until the water reaches 104°F This allows people
in the spa to temporarily override the normal temperature set-
ting. When the OFF button is pushed, the heater is turned off
regardless of the water temperature and will remain off until ei-
ther the ON button is pressed, or the start of the next normal
filter timer period.
Lights ON/OFF
The ON/OFF buttons allow manual operation that will override
any automatic control settings (e.g. timeclock). The manual set-
ting will remain active until the next scheduled automatic turn
on/off event.
Aux1 ON/OFF
Aux2 ON/OFF
The ON/OFF buttons allow manual operation that will override
any automatic control settings (e.g. timeclock). The manual set-
ting will remain active until the next scheduled automatic turn
on/off event.
Battery Replacement
The spa-side remote runs on two AAA batteries. Since the internal circuits are only
active when you push a button, it is anticipated that the original, factory-installed,
batteries should provide years of service. If you do not at least see a single flash of the
LED indicator when you push a button, then the batteries may need replacement.
It is IMPORTANT that you carefully follow this procedure to ensure that your spa-
side remote retains its watertight integrity:
1.
Use a Phillips head screwdriver to remove the 4 screws on the back of the spa-
side remote. These are special screws with built-in o-rings and are an important
part of making the spa-side remote watertight.
2.
Separate the 2 halves of the remote. Do not touch the o-rings or allow any
debris to fall onto the o-ring surface.
3.
Replace the 2 AAA batteries. Alkaline batteries are recommended for maxi-
mum life. If you observe any corrosion or water damage, contact the Goldline
Technical Service Dept Monday through Friday, 8AM to 8PM at 888-921-7665
for assistance.
4.
Carefully replace the back cover on the spa-side remote
5.
Re-install all 4 of the original screws.
a.
Loosely tighten all four screws
b.
Then go back and firmly tighten each screw.
6.
The spa-side remote will remember the ID code of the Aqua Logic base receiver,
so it is not necessary to perform the “Teach Wireless” procedure again. Verify
proper operation by pressing any button and observing 2 quick flashes indicat-
ing that the message was transmitted to the Aqua Logic base receiver and a
confirmation was received.
3
