Compatibility
This product is compatible with all Aqua Logic controls operating with software revi-
sion r1.10 or higher. To verify the software level of your Aqua Logic control, press the
Menu button (possibly multiple times) until “Diagnostic Menu” is displayed. Next,
press the “>” or “<“ keys (possibly mulitple times) until the main and display soft-
ware revision levels are displayed (the “main” rev should be r1.10 or higher).
If the software revision level is less than r1.10 contact the Goldline Technical Service
Dept. from Monday through Friday, 8AM to 8PM Eastern at 888-921-7665 for infor-
mation on upgrades.
Installation
1.
Batteries are installed at the factory:
There is no need to open the spa-side
unit.
2.
Base Receiver required:
For operation of the spa-side remote, the Aqua Logic
control unit must have a base receiver (AQL-BASE-RF) installed. The receiver
allows the Aqua Logic control until to communicate with the spa-side remote.
3.
Teach the unique Aqua Logic ID code
: The base receiver attached to the Aqua
Logic control unit has a unique ID code that ensures that your unit will not affect
other systems in the neighborhood, and likewise, their remote will not affect
your system. To teach the ID code to the spa-side remote unit:
a.
On any Aqua Logic display/keypad unit
press the “Menu” button (possibly multiple
times) until “Settings Menu” is displayed.
b.
Press “<“ or “>” (again, possibly multiple
times) until “Teach Wireless” is displayed.
c.
Press the “+” button to start the teaching
process.
d.
Press and hold any button on the spa-side
remote for 4 seconds. At this point the LED
indicator on the spa-side remote should flash
3 times and the Aqua Logic display should
say “Teach Wireless, Successful”. If the
LED indicator does not flash, then refer to
the Troubleshooting section of this manual
for additional information.
4.
Apply labels:
Aqua Logic PS series of control allow each output (e.g. AUX1) to
be re-named to what is actually being controlled. The spa-side remote comes
with a sheet of name labels—simply peel the appropriate label off the sheet and
apply to the appropriate set of buttons on the spa-side remote.
5.
Installation is complete:
you can now use the spa-side wireless remote.
Settings
Menu
Teach Wireless:
+ to start
Teach Wireless:
Sucessful
Press and hold
wireless button
1
