Golden Tornado 8-CYLINDER, Руководство по установке

Страница: 8 / 23

8
MOUNT SIDE BEAMS**
Note: Ensure Side Beam Saddle is positioned so that open end of
saddle is facing downward during installation shown in Figure 5.
1. Slide the Side Beam Saddle down over the Cross Beam as
shown in Figure 5.
Note: Ensure mounting holes in the bottom of the Side Beam
Saddle rest below and clear of the Cross Beam.
2. Attach one (1) 3/8” Flat Washer over two (2) 3/8” x 4 - 1/2” Hex
Bolts and insert them into the mounting holes on the bottom
of the Side Beam Saddle as shown in Figure 5.
3. Attach one (1) 3/8” Flat Washer, one (1) 3/8” Lock Washer,
and one (1) 3/8” Hex Nut to the two (2) protruding ends of
the Hex Bolts and hand tighten.
Note: It is important not to over tighten Hex Nuts to allow for Side
Beam adjustability.
4. Repeat these steps three (3) more times, once for the
opposite side of the Side Beam, and twice for the second
Side Beam.
Note: Please return to this step when instructed to full tighten
hardware.
PARTS REQUIRED TO MOUNT SIDE BEAM
Side Beam Saddle
3/8” Flat Washer (16)
3/8” x 4 - 1/2” Hex Bolt
(8)
Side Beam (2)
3/8” Lock Washer (8)
3/8” Hex Nut (8)
Figure 5