Golden Tornado 8-CYLINDER, Руководство по установке

Страница: 15 / 23

15
MOUNT HYDRAULIC CYLINDER(S)
cont.
Note: Ensure Hydraulic Cylinder(s) are tightly fastened as
described in previous step before continuing.
1. Align the upper Hydraulic Cylinder mounting hole with the
corresponding holes on the H-Frame as shown in Figure 14
& 15.
Note: The H-Frame may need to be lifted and rotated upward to
allow proper alignment.
2. Insert one (1) 1” Cylinder Pin into the cylinder mounting plate
through the Hydraulic Cylinder upper mounting hole as
shown in Figure 15.
3. From the inside of the mounting plate, insert one (1) 3/8” Hex
Bolt through the mounting plate and the hole on the Cylinder
Pin shown in Figure 15.
4. Attach one (1) 3/8” Lock Washer and one (1) 3/8” Hex Nut to
the protruding end of the Hex Bolt and fasten with
appropriate wrench until secure as shown in Figure 15.
5. Repeat these steps for the remaining seven (7) Hydraulic
Cylinders.
PARTS REQUIRED TO MOUNT HYDRAULIC
CYLINDER(S)
Hydraulic Cylinder (8)
3/8” Lock Washer ( 8)
3/8” Hex Nut ( 8)
3/8” x 1- 1/2” Hex Bolt ( 8)
3/4” Cylinder Pin ( 8)
Figure 14
Figure 15