background image

CS-9010,9020 

说明书  /  

INSTRUCTION MANUAL

  2

5.  压脚ME0118-0A的高度调整

1)工作物的毛边(如鞋底的毛边,鞋面的内里)必需在压脚ME0118-0A与下刀

ME0202-0A之间,很容易滑动。

2)压脚ME0118-0A如太低时,工作物移动困难,毛边修削不干净,如太高时,工作容

易被修削到。

3)压脚ME0118-0A的高度调整,只需转动ME0302-0A、ME0303-0A的螺丝,调整完

毕,将ME0302-0A、ME0303-0A螺帽锁紧。

6.  研磨上刀ME0112-0A的方法

1)松开ZMB04011螺丝,将压脚ME0118-0A移往右方。
2)松开ZMJ04001螺丝,取下ME0111-0A上刀板,取出上刀ME0112-0A。
3)将上刀ME0112-0A置於机器后侧的磨刀固定架ME0309-0A,刀刃斜面朝下,轻微

与砂轮ME0305-0A往复接触,接触时间越短越好,以免烧焦,或沾水亦可。

4)上刀ME0112-0A研磨完毕,需将毛边用细磨石磨掉,将上刀ME0112-0A与下刀

ME0202-0A接触的平面用细磨石磨平。

5)磨刀固定架ME0309-0A,可调整上下、左右,以吻合上刀的角度。

5. ADJUSTING POSITION OF PRESSING LEG ME0118-0A

1)

The work piece, stationed between pressing leg ME0118-0A and under 

cutter ME0202-0A should easily pass through during trimming of the 
product (Such as shoe sole spews and its inner lining).

2)

If the pressing leg ME0118-0A is too low, work piece would have 

difficulty moving through and trimming of spew would not be clean cut. 
If its too high, work piece would be badly cut off easily.

3)Turning screws 

ME0302-0A

ME0303-0A to adjust the height of pressing leg 

ME0118-0A after adjustment, retighten ME0302-0A

ME0303-0A screw cap.

6. SHARPENING UPPER CUTTER ME0112-0A

1)

Release screw ZMB04011, move pressing leg ME0118-0A to the right.

2)Release screw 

ZMJ04001, remove upper cutter plate ME0111-0A and thus 

upper cutter ME0112-0A.

3)Place upper cutter 

ME0112-0A on the grinding frame ME0309-0A, located at 

the rear of the machine, With blade facing downward, constantly slightly 
touching grinding wheel ME0305-0A.Time of touch should be as short as 
possible to prevent burnt, water covered be added too.

4)After completion of grinding, use smooth grade grind stone to rid of the 

spew from the blade.

5)The touching blade side of upper and under cutter should be grind level 

too. Grinding frame ME0309-0A can be adjusted up-down, left-right to 
meet the angle of the upper cutter.

GOLDEN WHEEL

Отзывы: