Golden Technologies GP162, Руководство пользователя

Страница: 22 / 38

22
VII. OPERATION
DRIVING: Joystick Power On/Off Button
To turn on the power to your LiteRider Envy , press the power button. If the
system is healthy, the Status indicator (through the Power Button) will light up
green, and the Battery Gauge will display the current battery status.
Power Off
If there is a fault with the system when powering up, the status indicator will indicate a
fault with a series of red flashes (see “Diagnostics”) on page 25. If the fault is one that
prevents the power chair from driving, then the battery gauge will flash continuously.
To turn off the power to your LiteRider Envy , press the power button; the system
will power down and the Status indicator will switch off.
Power On
In the unlikely event that the power chair is in a runaway situation, press
the power button to perform an EMERGENCY STOP
.
Drive Inhibit Indication
Drive inhibit mode is indicated by the battery gauge
with a right-to-left light sequence.
The light sequence starts with the green LED on the
right-hand side, and one-by-one, each LED will switch
on then off. When the sequence completes at the left-most
red LED, it begins again at the right-hand side.
The light sequence continues until the error condition
has been cleared.
Drive Inhibit Light Sequence
OONAPU
OONAPU (“ Out Of Neutral At Power Up ”) is a safety feature that prevents accidental
movement of the wheelchair, either when powering up, or when the wheelchair comes
out of an inhibit state.
If the LINX LE System is turned on (or comes out of an inhibit state) while the joystick is
not in the center position, an OONAPU
warning is displayed. During an OONAPU
warning, the battery gauge LEDs will flash continually to alert the user, and the chair
will not drive. If the joystick is returned to the center position within five seconds, the
warning will clear and the wheelchair will drive normally.
However, if the joystick remains out of neutral for longer than five seconds, an OONAPU
error will occur; the error is displayed by the Status indicator flashing red, and the chair
will not drive. To clear the error, return the joystick to the neutral position and power the
unit off and then on again.
Start